ATF Cable Policy

The Brookhaven Accelerator Test Facility (ATF) is a users' facility where many users and experiments share the resources. One of the most valuable resources is cables used for signals (50 ohm), video signals (75 ohm), control cables and power supply cables. Since the number of cables installed at the ATF is very large, it is absolutely necessary that the following policy be observed:

  1. No users shall disconnect any ATF facility cables without prior agreement with ATF operation coordinator, or ATF operator.
  2. All cables, including power line extension cord, must be labeled, and installed according to standard electrical safety codes at BNL, and registered with an ATF electronics technician.
  3. Any temporary cables must be removed immediately after their use.
  4. All users should inform the ATF user coordinator when the cables are no longer in service.
  5. In ATF experimental areas, the following color scheme is to be used for Ethernet cables:

    Yellow BNL network
    Pink A network
    Purple B network
    Blue GB cameras
    Green Temp/Humidity sensors
    Grey/White Off-network devices (motors etc.)
    All newly-installed Ethernet cables must be rated CAT6 or higher.

Top of Page

Last Modified: May 10, 2012
Please forward all questions about this site to: Christina Swinson