February 17, 2007
UPTON, NY - If a so-called "dirty bomb" exploded in a populated area, first responders would have to make immediate decisions to lessen health impacts on people who might be exposed to radioactive material. Brookhaven National Laboratory health physicist Stephen Musolino will be among five speakers who will discuss aspects of a response to such a scenario at the 2007 annual meeting of the American Association for the Advancement of Science (AAAS) in San Francisco. During the session, which will be held Saturday, February 17 at 2 p.m., speakers will offer guidance to first responders, planners, and other decision makers for protective actions during the first 48 hours after a dirty-bomb - formally known as a radiological dispersal device (RDD) -- has been detonated.
Along with Sandia National Laboratories senior scientist Frederick Harper, Musolino will participate in a session titled "Coping with a Dirty-Bomb Detonation." Musolino's presentation is "Evacuate or Shelter in Place: A Dirty-Bomb Case Study."
"By the time it is known that an attack has occurred, most likely there will have been casualties, all the radioactive material will have been released and it will have begun to disperse," Musolino said. "The goal of our research is to provide science-based response recommendations to the U.S. Department of Homeland Security to consider for use in community preparedness activities."
Over the past two decades, more than 600 explosive experiments were conducted at Sandia to determine how the radioactive material in a RDD would disperse in the environment through aerosolization, which forms a cloud of particles. In these experiments, the quantities of material used to simulate the radioactive material, the shock physics, and the aerosol physics are representative of what might occur in the detonation of an actual device. This information was then applied to predict the dispersal of actual radioactive sources using many different device designs. Harper and Musolino published the study's results in a cover article in the April issue of the Health Physics journal.
The research, said Harper, was performed on many different forms of materials - including ceramics, metals, powders, and liquids - so that the dispersal characteristics of most realistic radioactive sources could be predicted accurately.
"We focused on sophisticated aerosolization techniques to provide the responders with guidance based on what is realistically possible," Harper said. "We've also performed experiments investigating some of the more probable aerosolization techniques that terrorists might employ."
Based on the experiments, Harper and Musolino recommended establishing a "high zone" with boundaries of 500 meters in all directions from the point of detonation. Because there is a good set of experiments behind this recommendation, first responders can follow it without radiation measurements if they know there is radiation associated with the explosion. Responders are advised to evacuate this "high zone" and control access to prevent uncontaminated people from entering the affected area. "These new strategies will speed up lifesaving efforts to aid the injured victims and minimize the overall radiation dose to the public,' Musolino said. "I hope a terrorist act with a RDD never happens," he continued. "But if it does, we want the first responders to have the best science behind the tough decisions they will make in those first critical hours."
The research was funded primarily by the Department of Energy and the Defense Department's Defense Threat Reduction Agency. Recently, the Department of Homeland Security (DHS) and Nuclear Regulatory Commission contributed to the work, with DHS coordinating the outreach effort with the first responder community.
2007-594 | Media & Communications Office
You can receive a monthy reminder email when a new issue of eNews is available. If you are not already receiving this email, then subscribe below.